Triplett TVR10/100/1000 - Manual (Page 31)

PoE ENDSPAN
MIDSPAN
PoE
between) and test. You should see activity (a Data/Link LED) and a
Speed/Duplex LED. If you don't, the LAN device is faulty. If you do,
the cable is faulty.
Test example #4. TEST for Hub/Switch or PC at the far end of
a cable using the TVR1000’s Cable Test Jack (continuity test).
Note: This test uses the CABLE TESTS section of the Main Unit to
perform its tests. It is a quick way to determine the number of cable
pairs connected to the hub/switch or PC (e.g. if switch requires
four pairs and only two are connected). Use this test if no activity
has been detected by the Data/Link and Speed/Duplex tests. This
lack of activity may be caused by a misplaced or disconnected
patch cable or the installed cable may be faulty. The power may be
turned OFF as well. This connection test is so quick, it should be
used whenever there is a lack of activity. The connection test
Cable Tests jack is connected
to the hub or PC via the wall socket
Straight thru
patch cable
(included)
Wall socket
to hub/switch or PC
Test example #4
Testing a remote hub/
switch for continuity
29
CAUTION: Do not plug the Cable Tests jack into PoE.
Damage may result.