Tri Tool 601SBM Clamshell Air - Manual (Page 9)

9
Model 601SBM Low Profile Clamshell
92-0092 Rev. 131230
NOTE:
MAINTENANCE
Clean Up
All components should be cleaned and coated with a light film of oil prior to use. Use
a clean, non-detergent oil, preferable SAE 10 (90 SSU or lighter).
The Motor warranty is void if damage occurs from contaminated air or lack of
lubrication.
If the Clamshell is operated in such a manner that the Tool Blocks collect debris
while cutting, the Tool Blocks and the Feed Screws should be cleaned after each
cutting operation.
RECOMMENDED MAINTENANCE SCHEDULE
Daily maintenance when the unit is in operation:
Wipe the unit down and spray with rust preventative under severe humidity
conditions.
Visually inspect for loose screws, missing screws, damage, etc.