Tri Tool 601SBM Clamshell Air - Manual (Page 22)

22
TRI TOOL INC.
92-0092 Rev. 131230
Dead Man Switch Warning
WARNING:
DO NOT OVERIDE THE DEADMAN SWITCH.
Locking down, obstructing, or in any way
defeating the deadman switch on this unit
may result in serious injury.
Check for proper alignment of the Feed Sprockets. Refer to the picture “Approach of
the Feed Pin to the Feed Sprocket”.
Run the Headstock slowly with the Feed Pin ‘in’ to insure that the Sprocket is set
right. (Do not run at full speed during the first revolution.)
The Air Motor working speed will be about one half of the no-load speed. Refer to
the chapter on “Cutting Speeds” for speed selection charts.
Engage the feed by pushing the Tripper Shaft in.
Monitor the cutting operation.
Apply cutting fluid as necessary.
The Feed Pin will break if the alignment of the Feed Pin to the Sprocket is
not correct
NOTE:
Approach of the Feed Pin to the Feed Sprocket