Tri Tool 601SBM Clamshell Air - Manual (Page 11)

11
Model 601SBM Low Profile Clamshell
92-0092 Rev. 131230
Lightly turn in the remaining Bearing Adjustment Set Screws in the order shown until
all touch the Bearing.
Relax Bearing Adjustment Set Screws (1,3,5, and 7) and resnug them so that all of
the Bearing Adjustment Set Screws are evenly loaded against the Bearing.
Connect the air supply and apply power to the Clamshell so that it is running at full
speed.
Adjust the Set Screws (1 through 8) so that the Clamshell rotation slows slightly.
Listen for a change in the sound of the Air Motor. Refer to the Bearing Adjustment.
Screw locations for the recommended sequence.
Adjust the Set Screws in small increments so that the bearing is loaded evenly.
All of the Set Screws should be snugged to ensure that the bearing is uniformly
loaded.
Drive torque as measured at the drive socket should be 5 to 10 ft-lbs. (7 to 14 N-m).
Bearing Adjustment Screw Locations