Tri Tool 601SBM Clamshell Air - Manual (Page 18)

18
TRI TOOL INC.
92-0092 Rev. 131230
OPERATION
Locking Screw Locations
Read the operation instructions before operating the Model 601SBM Low Profile
Clamshell.
Configure the clamshell for the specific task required
Mount the Tool Blocks and Tripper Bracket onto the Clamshell.
Select and install the proper Clamping Pad Set into the Clamshell. Refer to the
section on ‘Clamping Pad Sets’ later in this booklet.
Do not install the Tool Bits until the Clamshell has been installed on the pipe.
INSTALLATION OF THE CLAMSHELL ON AN IN-LINE PIPE
Separate the two halves of the Clamshell.
Disengage the Air Motor by removing the Motor Hold-down Bolt and removing the
Air Motor from the drive socket.
Rotate the Headstock until the split-lines of the Headstock match the split-lines of
the Housing.
Unbolt the two halves of the Clamshell.