Tri Tool 600RBL and 600SB Series OD Tracking Module - Manual (Page 9)

9
Model 600 SB and RBL OD Tracking Module
92-0732 Rev. 131009
5.05 TRIPPER BRACKET ASSEMBLY, LUBRICATION AND
ADJUSTMENT
1. Back off the Ball Plunger until it disengages from the Tripper Shaft Assembly.
2. Remove the Tripper Guard and the Shoulder Bolt. Then remove the Tripper
Lever Handle.
3. Remove the Tripper Shaft Assembly from the block and remove the old
lubrication.
4. Apply fresh lubrication to the Tripper Shaft Assembly.
5. Re-install the Tripper Shaft Assembly & Lever Handle into the block.
6. Screw in the Ball Plunger until it is in the Slot on the Tripper Shaft.
7. Re-attach Tripper Guard.
BALL PLUNGER
TRIPPER GUARD
SHOULDER BOLT
TRIPPER SHAFT
ASSY
TRIPPER
LEVER HANDLE
Figure: 2. Sites for Tripper Lubrications
5.06 LUBRICANT RECOMMENDATIONS
• The Drive Gears require a heavy duty grease such as “Chevron Ultra Duty NLGI
2” (P/N 68-0024).
• The Slide Rails and Tool Blocks require a light oil such as SAE 10 light
machine oil.
• The Feed Screw for the Tool Block and Tripper Block Assembly requires a SAE
10 light machine oil for normal conditions, and under dusty conditions a silicone,
graphite, or molybdenum disulfide ‘dry’ lubricant.
• You can use a light film of all-purpose grease. Be sure to check it for grit
contamination frequently.