Tri Tool 600RBL and 600SB Series OD Tracking Module - Manual (Page 13)

13
Model 600 SB and RBL OD Tracking Module
92-0732 Rev. 131009
8. Remove the spring compression cap screws.
9. Rotate the Headstock another full revolution, check that the rollers are in
complete contact with the pipe
CAUTION: Do not fully compress the springs or allow them to be
fully depressed. The springs of the OD Tracking Module must adjust
compression to work properly.
6.06 CHECK THE TRIPPER SHAFT TO SPROCKET ALIGNMENT
1. Rotate the Headstock until the sprocket on the OD Tracking Modules
approach the tripper shaft.
2. The Tripper Shaft must strike the sprocket on the edge of the tooth. Do not let
the Tripper Shaft strike the point of the sprocket tooth.
Figure: 5. Tripper Shaft Alignment
CAUTION: If the Tripper Shaft to sprocket alignment is not correct: the
Tripper Shaft or the sprocket or both may break when the Clamshell is
operated.
TRIPPER SHAFT
SPROCKET
TRIPPER SHAFT
SPROCKET
Correct Alignment Incorrect Alignment