Tri Tool 600RBL and 600SB Series OD Tracking Module - Manual (Page 5)

5
Model 600 SB and RBL OD Tracking Module
92-0732 Rev. 131009
CAUTION: HYDRAULIC DRIVES
Do not touch the components of hydraulic systems, except for
the controls during and after equipment operation. The hydraulic
system can get hot enough to cause burns. Wait for the equipment
to cool down before handling.
Do not damage the hydraulic lines.
Keep quick-disconnects clean because grit contamination causes
malfunctions and damages the equipment.
Do the following to reduce the risk of damage to the power and
control cords:
• Do not pull or run over the cords or the cables.
• Keep all control and power cords away from fluids and water.
WARNING: After a cut, one or both sides of a poorly secured pipe
can move and cause death or serious injury.
CAUTION: ELECTRIC MOTORS
Only use the recommended AC voltage power sources.
Observe all electric shock hazard procedures.
Do the following to reduce the risk of damage to the power and
control cords:
• Do not pull or run over the cords or the cables.
• Keep all control and power cords away from fluids and water.
CAUTION: PNEUMATIC TOOLS
Do not touch the components of pneumatic systems, except for
the controls during and after equipment operation. The pneumatic
system can get hot enough to cause burns. Wait for the equipment
to cool down before handling.
Check the exhaust muffler. Broken or damaged mufflers can restrict
air flow or cause excessive noise.
Bleed off all residual air pressure before disconnecting air lines.
Air that is over or under pressure or contaminated can cause
malfunctions including delayed or irregular starts.