Tri Tool 600RBL and 600SB Series OD Tracking Module - Manual (Page 14)

14
Model 600 SB and RBL OD Tracking Module
92-0732 Rev. 131009
Do the following if you need to correct the alignment:
1. Loosen the two cap screws on the Tripper Bracket.
2. Adjust the two cap screws to a gap between 0.10" to 0.20" (.25 to .51 mm).
Figure: 6. Tripper Bracket Gap
6.07 INSTALLATION OF THE TOOL BITS
1. Select the Tool Bit set you need.
CAUTION: Do not use dull too bits, improperly designed tools bits or
Tool Bits that were not manufactured by Tri Tool Inc. The use of these
Tool Bits may result in poor performance, and may constitute abuse of
the equipment and therefore void the Tri Tool Inc. factory warranty.
2. Install the Tool Bit.
3. Adjust the height of the Tool Bit so it almost touches the highest point of the
pipe.
4. Tighten the set screws of the Tool Bit set.
5. Rotate the Headstock by hand to check that there is enough clearance
between the Tool Bits and the pipe.
CAP SCREWS
TRIPPER SHAFT
.010" TO .020"
(.25mm TO .51mm)
NECESSARY GAP