Tri Tool 212B Beveler Single Point Flange Facer - Manual (Page 8)

92-0729 : Rev. 070928
TRI TOOL INC.
8
Attach the two tripper brackets to the 212B BEVELMASTER TM .
Loosen the Torque Acceptance Keys in the 212B BEVELMASTER TM .
Remove the cover plate from the bearing of the Single Point to gain access
to the adjustment screws for the split mandrel sleeve.
Loosen the 16 set screws and 8 cap screws that hold the Split Mandrel
Sleeve in position.
Slide the Mandrel Boss Assembly into the Single Point and through the 212B
Bevelmaster
TM until it comes to a solid stop against the Torque Acceptance
Keys.
Rotate the Mandrel Boss Assembly as required until the mandrel slots
engage the Torque Acceptance Keys.
CAUTION:
Since the Mandrel Shaft will contact the torque acceptance keys before
the Feed Nut engages the Mandrel Boss assembly threads, caution
should be taken not to force (or Allow) the Mandrel to impact the lead
threads of the Feed Nut with the lead threads of the Mandrel.
Engage the Feed Handle and wind the Mandrel Boss Assembly back into the
Single Point.
Tighten the 8 cap screws in the Split Mandrel Sleeve in the order shown, until
the Mandrel Boss Assembly is located centrally in the Single Point and slides
with some resistance when the feed handle of the 212B Bevelmaster
TM is
rotated.
Tighten the 16 Screws around the split sleeve mandrel.
Replace the Cover Plate.
7
3
2
6
8
4
1
5