Tri Tool 212B Beveler Single Point Flange Facer - Manual (Page 4)

92-0729 : Rev. 070928
TRI TOOL INC.
4
Air tools. Check the exhaust muffler. Broken or damaged mufflers can
restrict air flow or cause excessive noise. Use air motors only with a filtered,
lubricated and regulated air supply. Dirty air, low pressure air or over
pressure air will cause malfunctions, including delayed starting.
AREA EQUIPMENT:
Secure work. Whenever possible use clamps, vises, chains and straps to
secure pipe.
Make sure the tool is secured, it is safer to have both hands free to operate
the tool.
TOOL USE:
Us the right tool and tool bit for the job. Do not use a tool which is incorrect
for the job you are doing.
Keep the tool bits fully engaged in the tool bit holders. Loose bits are a
safety hazard.
Disconnect power supply during setup and maintenance. Use all stop or
shut-off features available when changing or adjusting tool bits, maintaining
the tool, or when the tool is not in use.
Remove adjusting keys and wrenches before applying power to the
equipment. Develop a habit of checking the tool before turning it on to make
sure that all keys and wrenches have been removed.
Do not force tools. Tools and tool bits function better and safer when used at
the feed and speed rate for which they were designed.
Do not reach into rotating equipment. Do not reach into the rotating head
stock to clear chips, to make adjustments, or to check surface finish. A
machine designed to cut steel will not stop for a hand or an arm.
Handle chips with care. Chips have very sharp edges and are hot. Do not
try to pull chips apart with bare hands; they are very tough.
Avoid unintentional starts. Do not carry or handle tools with your hand on the
operating switches or levers. Do not lay the tool down in a manner which will
start the drive. Do not allow the tool to flip around or move when adjusting or
changing tool bits. Store idle tools properly.
Disconnect tools from the power source and store in a safe place. Remove
tool bits for safe handling of the tool.