Tri Tool 212B Beveler Single Point Flange Facer - Manual (Page 23)

23 92-0729 : Rev. 070928
212B BEVELMASTER TM SINGLE POINT / FLANGE FACER
Problem: There is a loss of hydraulic power.
The hydraulic supply pressure is too low.
The hydraulic filter is plugged.
The hydraulic line size is insufficient.
The hydraulic line is too long.
Problem: The Bevelmaster TM is slipping on the pipe or tube.
The jaw blocks are not in full contact with the pipe or tube.
The clamping pressure is too light.
Scale and/or other foreign material is present on the pipe or tube.
Weld seams, swelling, or bumps under the Clamping Pads are preventing full
contact.
Dull tool bits are causing extra force in the axial and/or radial direction.
The pipe or tube wall is too thin which allows the tube wall to flex and the machine
to move.
Problem: The air motor will not start.
The air power supply is shut off.
The air motor is damaged and will not run free.
The air motor needs lubrication.
Add lubrication and do not run the air motor for a few minutes, then try running the
air motor again.
Tap on the side of the air motor casing lightly with a piece of wood or with a soft
rubber mallet just in case the vanes may be sticking. Sand or other foreign material
may be in the vanes of the air motor..
Problem: The hydraulic motor will not start.
The hydraulic power supply is shut off.
The hydraulic motor is damaged and will not run free.