Tri Tool 212B Beveler Single Point Flange Facer - Manual (Page 14)

92-0729 : Rev. 070928
TRI TOOL INC.
14
NOTE:
Feed Rate increments of .001” (.025mm) is for one Tripper, to double the
feed rate engage Both Tripper Wheels.
FEED SCREW ASSEMBLY
Select the Feed Rate.
Turn the Feed Adjustment Screw to the required feed rate.
Securing The Model 212B BEVELMASTER TM .
Once in position, rotate and tighten the torque keys of the model 212B
Bevelmaster
TM , (located ahead of the feed handle) to secure the position and
restraint the cutting torque.
Connect the power source to the model 212B Bevelmaster TM , and start the
cutting operation as described in “Cutting speeds and feeds” of this operator
manual.
CAUTION:
Do not start the tool without having read and understood the “Cutting
speeds and feeds” section of this manual.
Machining of the Pipe.
Rotate the Feed Handle to move the Cutting Tool into position to start the cut.
Lock the Torque Acceptance Keys against the Mandrel Boss Shaft, to lock the
212B Single Point in position.
Select the direction of feed. Push the Feed Knob In to feed Radially in, Pull
out to feed Radially Out.
CAUTION: Changing feed direction must be accomplished with the power off.