Tri Tool 212B Beveler Single Point Flange Facer - Manual (Page 13)

13 92-0729 : Rev. 070928
212B BEVELMASTER TM SINGLE POINT / FLANGE FACER
Position the Tool Holder For Cutter.
Adjusting The Cam Track Plate.
Loosen the lock block screw then pull the plunger pin. Pivot the cam track
plate to the desired angle, each preset adjustment hole in the angle plate is
in 5° increment from 0° to 30°, one at 37 1/2° and one at 45°. Let go of the
plunger pin into a preset adjustment hole and tighten the lock block screw
securely.
Positioning The Cam Track Plate Assembly.
Loosen the three angle plate locking cap screws. So that the cam track plate
assembly can slide easily with the tool holder assembly.
Depress the feed knob to its innermost position (infeed) or pull it to its outer
most position (outfeed), rotate the feed knob clockwise until the tool bit insert
is approximately 1/8” (3.2mm) passed the inside diameter of pipe to be cut.
Push outward the cam track plate assembly, until the cam follower is at the
bottom end of the cam track plate slot, this will be the end of the radial travel.
Now tighten the three angle plate locking cap screws.
Positioning The Tool Holder For The Cutting Operation.
Pull the feed knob to its outermost position and rotate the feed knob
clockwise until the tool bit clears the OD of the pipe or tube to be cut
(approximately .050” (1.3mm) above the highest point on the pipes OD).
Rotate the 212B Bevelmaster TM feed handle clockwise until the tool holder is
above the pipes OD by the amount of material to be removed in one pass
(depending on material as described in cutting speeds and feeds mentioned
in this manual).
MANDREL BOSS
ASSEMBLY
WRENCH
MANDREL
FINAL PREP
LOCATION
PIPE
JAW
BLOCK
RAMP
BUTT
PLATE
PIPE TO MANDREL LOCATION