Tri Tool 212B Beveler Single Point Flange Facer - Manual (Page 5)

5 92-0729 : Rev. 070928
212B BEVELMASTER TM SINGLE POINT / FLANGE FACER
MACHINE SPECIFICATIONS
IN GENERAL:
The Model 212B Single Point/Flange Facer Kit is supplied to provide the Model
212B BEVELMASTER
TM with beveling, and flange facing capabilities over a
cutting range of 8.20” (208.3mm) to 24.00” (609.6mm) diameter, beveling angles
between 0° and 45
0 .
This kit allows a quick, easy field conversion of the 212B from a beveling
configuration, to a Single Point configuration and back again as required.
SPECIFICATIONS:
212B Single Point: Weight: 66 Ibs ( 29.9Kg).
CUTTING CAPACITIES:
Range: 8.20” (208.3mm) I.D.to 24.00” (609.6mm) O.D.
Bevel Angle: 0° to 45°.
Feed Rate: 0 - .026” (0 - .66mm) per revolution.
Max Wall Thickness: 1.50” (38.1mm) at 37.5°.
2.34” (59.4mm) 37.5°/10° Compound Bevel.
Maximum Chip Width: .20” (5.1mm) (Depending on Material).
Alignment: When used with Miter Mandrel;
Angular: ± 5°.
Offset: ± .190” (4.8 mm).
MATERIAL:
Mild steels, Chrome steels (Rc 35 max.), Stainless steel, Copper-nickel and
Aluminum.
Inconel and some other high temperature alloys may require special proce-
dures as a function of wall thickness and type of end preparation.
Contact Tri Tool’s Engineering Department for details.
MOUNTING:
The 212B Single Point can be mounted in pipe or tube with an internal
diameter from 6.10” (155.0mm) through 23.50” (596.9mm).