Tri Tool 212B Beveler Single Point Flange Facer - Manual (Page 15)

15 92-0729 : Rev. 070928
212B BEVELMASTER TM SINGLE POINT / FLANGE FACER
Connect the power supply to the 212B BEVELMASTER. TM
Turn the power supply on, slowly, letting the cutter rotate around the pipe to
ensure that it does not hit any part of the pipe.
Adjust the cutting speed by rotating the flow control valve on the motor.
(Refer to the Cutting Speed Section for the recommended cutting speed).
Engage the Tripper Wheel(s) to start the cut.
At the end of the cut stop the motor.
Release the Torque Acceptance Keys and back the machine away from the
pipe by turning the Feed Handle, on the 212B Bevelmaster
TM , Half a turn.
Reverse the direction of the feed by Pushing, or Pulling the Feed Knob. Turn
the feed Knob until the cutter returns to the start of the cut.
Rotate the Feed Handle, on the 212B Bevelmaster TM , to the next depth of cut,
lock the Torque Acceptance Keys and begin cutting.
Continue until the Prep is completed.
NOTE:
Use a Wrench to speed the resetting of the Cutting Tool in the end of
the Feed Knob on the 212B Single Point Feed Assembly
CAUTION:
Disconnect Power supply.
Loosen the Torque Acceptance Keys and back the machine away from the
pipe by turning the Feed Handle, on the 212B Bevelmaster
TM .
Remove the 212B Single Point from the Pipe.
For the Miter Mandrel set up, turn the Wrench until the 212B Single Point
comes away from the Miter Mandrel. Remove the Miter Mandrel separately
from the pipe.
For the Jaw Block set up, turn the Wrench on the Mandrel until the Jaw
Blocks are released from the inside of the pipe, pull the machine away from
the pipe.
If the next bevel is the same repeat the previous set up procedure.
If the bevel is a different angle the Cam Track Plate Assembly will need to be
reset.
If the Cutting Tool runs out of feed travel, the actuating arm of the feed
assemble will trip, stopping the feed. Stop the machine and reset the
Tool Assembly to achieve the correct feed travel.