Tri Tool 212B Beveler Single Point Flange Facer - Manual (Page 12)

92-0729 : Rev. 070928
TRI TOOL INC.
12
NOTE:
CAUTION:
Set the Tool Holder to the required bevel angle required and tighten the Lock
Block.
NOTE:
Using the 212B Single Point and Miter Mandrel Kit.
The Miter Mandrel Head this should now be fitted into the pipe ready to accept
the 212B Single Point.
Refer to the Model 212B-Miter Mandrel Head Manual (#92-0738).
Attach the 212B Single Point to the Miter Mandrel. Align the two dowel pins in
the Mitre Mandrel Head with the holes in the Mandrel Boss Assembly and
tighten the 212B Single Point Wrench to secure the system to the Miter
Mandrel ready for machining.
Using the 212B Single Point and 3 Jaw Head Kit.
Attach the Mandrel Head to the Mandrel Boss Assembly using the 6 cap
screws. Engage the Butt Plate Lead screw by turning the Wrench in the
Mandrel Boss Assembly.
Select the recommended Jaw Blocks and Ramp Set combination that
matches the Internal Diameter of the pipe (Refer to the Jaw Blocks and Ramp
Set Table).
Install the Single Point into the pipe.
CAUTION:
Tighten the Wrench to force the Jaw Blocks out to the inside diameter of the
pipe.
NOTE: Insure that no Tool Bit is installed backwards.
Use of dull or improperly designed Tool Bits or Tool Bits not manufac-
tured by Tri Tool Inc. may result in poor performance and may consti-
tute abuse of this machine and therefore voids the Tri Tool Inc. Factory
Warranty.
The cutting edge of the tool must be located on the radial centerline.
The Can Track Plate /assembly has a pre-selected angular position
between 0
0 and 30 0 in 5 0 increments, plus a position at 37.5 0 and 45 0 .
These are selected by engaging the plunger pin at the appropriate
position.
In order to avoid cutting the Jaw Blocks during the machining opera-
tion, the Mandrel must be installed beyond the final end preparation.