Draytek Telnet Command 1.11 - Manual (Page 121)

Telnet Command Reference Guide V1.1 115
2.23.5.3 voip sip ep
This command allows users to set
voip sip ep n [-]
voip sip ep n[…]
Syntax Description
n It means the index number of the VoIP settings.
- The available commands with parameters are listed below:
-o It means the default dial out account (1 ~ 6).
-L It means the hot line sip url (max. 63 characters).
-l It means to enable or disable hot line (0: disable, 1: enable)
-w It means to enable or disable call waiting (0: disable, 1: enable)
-x It means to enable or disable call transfer (0: disable, 1: enable)
-f It means to specify the call forwarding mode
(0: disable, 1: always, 2: busy, 3: no answer)
-F It means to specify call forwarding sip url (max. 63 characters).
-t It means to specify call forwarding timer (unit: second)
-d It means to enable or disable DND (Do Not Disturb, 0: disable,
1: enable).
-s It means to specify DND schedule s1[s2, s3, s4] (max. 4
schedule).
-h It means to enable or disable calling line identification
restriction (CLIR, 0: disable, 1: enable)
-u It means to specify CLIR mode.
(0: draft-ietf-sip-privacy, 1: rfc 3323/3325)
-z It means to enable or disable play dial tone when registered on
sip server.
-n It means to enable or disable session timer (0: disable, 1:
enable).
-m It means to specify session timer (unit: sec)
-8 It means to enable or disable T.38 fax relay (0: disable, 1:
enable)
-c It means to specify default call route (0: to VoIP, 1: to ISDN)
-p It means to specify alternate route to VoIP, 1 or 2 keys. The
valid digits are 0-9,*,#
-i It means to specify alternate route to ISDN, 1 or 2 keys. The
valid digits are 0-9,*,#
-q ISDN to VoIP call enable (0: disable, 1: enable)