Dynacord Professional Power Amplifiers - Manual (Page 59)

Cl s
eries
59
General CL 1600 CL 2000
Load Impedance 2 Ω 4 Ω 8 Ω 2 Ω 4 Ω 8 Ω
Maximum Midband Output Power, 1 kHz, THD=1% 1100 W 800 W 500 W 1500 W 1000 W 600 W
Rated Output Power, 20 Hz ... 20 kHz, THD <0.1% - 700 W 350 W - 850 W 450 W
Max. Single Channel Output Power
Dynamic-Headroom, IHF-A
2200 W 1200 W 625 W 2700 W 1450 W 750 W
Max. Single Channel Output Power Continuous, 1kHz 1500 W 950 W 550 W 1900 W 1150 W 650 W
Maximum Bridged Output Power 1 kHz, THD=1% - 2200 W 1600 W - 3000 W 2000 W
Maximum RMS Voltage Swing 1 kHz, THD=1% 72 V 80 V
Power Bandwidth, THD=1%, ref. 1kHz, half power @ 4Ω 10 Hz ... 60 kHz
Voltage Gain ref. 1 kHz 32 dB
Input Sensitivity at rated output power @ 8Ω, 1 kHz +4.7 dBu (1.33 V rms) +5.5 dBu (1.46 V rms)
THD at rated output power MBW=80kHz, 1 kHz < 0.05 %
IMD-SMPTE, 60 Hz, 7 kHz < 0.02 %
DIM 30, 3.15 kHz, 15 kHz < 0.01 %
Max. Input Level +22 dBu (9.76 Vrms)
Crosstalk, ref. 1 kHz at rated output power < -80 dB
Frequency Response, ref. 1 kHz 15 Hz ... 40 kHz (- 1dB)
Input Inpedance, active balanced 20 kΩ
Damping Factor, 1kHz > 300
Slew Rate 35 V/µs 35 V/µs
Signal to Noise Ratio, A-weighted 107 dB 109 dB
Output Stage Topology Class-H
Power Requirements 100 V, 120V, 220V, 230V, 240V, 50 Hz... 60 Hz (factory configured)
Power Consumption at 1/8 maximum output power @ 4 Ω 660 W 725 W
Protections Audio limiters, High temperature, DC, HF, Back-EMF, Peak current limiters, Inrush current limiters,
Turn-on Delay
Cooling Front-to-Rear, 3-stage-fans
Ambient Temperature Limits +5°C ... +40°C (40°F ... 105°F)
Safety Class I
Dimensions (WxHxD), mm 483 x 88.1 x 386.8
Weight 16 kg (35.3 lbs) 18.2 kg (39.7 lbs)
Optional Accesories:
Rear Rackmount 15.5“: D112 930 (NRS90262)
Rear Rackmount 18.0“: D112 933 (NRS90264)
LPN + Lo-Cut Filter: D112963 (NRS 90268)
CL 1600