Dynacord Professional Power Amplifiers - Manual (Page 58)

Cl s
eries
58
CL Series
technical specifications
General CL 800 CL 1200
Load Impedance 2 Ω 4 Ω 8 Ω 2 Ω 4 Ω 8 Ω
Maximum Midband Output Power, 1 kHz, THD=1% 600 W 400 W 240 W 900 W 600 W 350 W
Rated Output Power, 20 Hz ... 20 kHz, THD <0.1% - 300 W 150 W - 500 W 250 W
Max. Single Channel Output Power
Dynamic-Headroom, IHF-A
1100 W 580 W 300 W 1450 W 850 W 450 W
Max. Single Channel Output Power Continuous, 1kHz 800 W 480 W 270 W 1200 W 720 W 410 W
Maximum Bridged Output Power 1 kHz, THD=1% - 1200 W 800 W - 1800 W 1200 W
Maximum RMS Voltage Swing 1 kHz, THD=1% 50 V 62 V
Power Bandwidth, THD=1%, ref. 1kHz, half power @ 4Ω 10 Hz ... 60 kHz
Voltage Gain ref. 1 kHz 32 dB
Input Sensitivity at rated output power @ 8Ω, 1 kHz +1.15 dBu (0.88 V rms) +3.2 dBu (1.12 V rms)
THD at rated output power MBW=80kHz, 1 kHz < 0.05 %
IMD-SMPTE, 60 Hz, 7 kHz < 0.02 %
DIM 30, 3.15 kHz, 15 kHz < 0.01 %
Max. Input Level +22 dBu (9,76 Vrms)
Crosstalk, ref. 1 kHz at rated output power < -80 dB
Frequency Response, ref. 1 kHz 15 Hz ... 40 kHz (- 1dB)
Input Inpedance, active balanced 20 kΩ
Damping Factor, 1kHz > 300
Slew Rate 25 V/µs 30 V/µs
Signal to Noise Ratio, A-weighted 103.5 dB 105.5 dB
Output Stage Topology Class-AB Class-H
Power Requirements 100 V, 120V, 220V, 230V, 240V, 50 Hz... 60 Hz (factory configured)
Power Consumption at 1/8 maximum output power @ 4 Ω 600 W 500 W
Protections Audio limiters, High temperature, DC, HF, Back-EMF, Peak current limiters, Inrush current limiters,
Turn-on delay
Cooling Front-to-Rear, 3-stage-fans
Ambient Temperature Limits +5°C ... +40°C (40°F ... 105°F)
Safety Class I
Dimensions (WxHxD), mm 483 x 88.1 x 386.8
Weight 13.5 kg (29.8 lbs) 15 kg (33.0 lbs)
Optional Accesories:
Rear Rackmount 15.5“: D112 930 (NRS90262)
Rear Rackmount 18.0“: D112 933 (NRS90264)
LPN + Lo-Cut Filter: D112963 (NRS 90268)