Thinklogical Secure Console Server Manual - Manual (Page 64)

S e c u r e C o n s o l e S e r v e r M a n u a l , R e v . K , J u l y , 2 0 1 3 Page 64
Command Description
# CBIn Local Callback Inactivity Timer
# CBNy=n Store Callback Password
# CBPn Callback Parity
# CBRy Callback Security Reset
# CBSn Callback Enable/Disable
#Pn Set 11-bit Parity
#Sx Enter Setup Password
#S=x Store Setup Password
+VDR=x, y Distinctive Ring Report
+++AT Escape Sequence
%%%ATMTSMODEM Remote Configuration Escape Sequence
V.92 Commands
AT Commands
Command: AT Attention Code
Values: n/a
Description: The attention code precedes all command lines except A/, A: and escape sequences.
Command: ENTER Key
Values: n/a
Description: Press the E NTER ( R ETURN) key to execute most commands.
Command: A Answer
Values: n/a
Description: Answer call before final ring.
Command: A/ Repeat Last Command
Values: n/a
Description: Repeat the last command string. Do not precede this command with AT. Do not press E NTER to execute.
Command: B n Communication Standard Setting
Values: n = 0–3, 15, 16
Default: 0 and 15
Description: B0 Select ITU-T V.22 mode when modem is at 1200 bps.
B1 Select Bell 212A when modem is at 1200 bps.
B2 Deselect V.23 reverse channel (same as B3).
B3 Deselect V.23 reverse channel (same as B2).
B15 Select V.21 when the modem is at 300 bps.
B16 Select Bell 103J when the modem is at 300 bps.
Command: D s Dial
Values: s = dial string (phone number and dial modifiers)
Default: none
Description: Dial telephone number s, where s may up to 40 characters long and include the 0–9, *, #, , B, C, and D
characters, and the L, P, T, V, W, S, comma (,), semicolon (;), !, @, ^ and $ dial string modifiers. Dial
string modifiers:
L Redial last number. (Must be placed immediately after ATD.)
P Pulse-dial following numbers in command.
T Tone-dial following numbers in command (default).
Switch to speakerphone mode and dial the following number. Use ATH command to hang up. W
Wait for a new dial tone before continuing to dial. (X2, X4, X5, X6, or X7 must be selected.)
, Pause during dialing for time set in register S8.