Thermon TESH - Manual (Page 10)

INSTALLATION GUIDELINES SERIES HEATING CABLES PAGE 8
THERMON...The Heat Tracing Specialists ®
TEP0118U-1111
Typical heat tracing system using stabilized design
Power cable 1
Circuit switch with indicating lamp (padlockable) 2
Thermostat controller 3
Cold lead cables
In case heat dissipation of TES cable is lower than 16
W/m, the heating cable may be connected directly into
the junction box or thermostat without a cold lead. MI
cables always via cold lead cable.
5
4 Junction box (Eexe)
Cold lead junction
(see point 5)
6
Series heating cable
Star connectionbox
7
8
3-phase
via interposing
relay or contactor
Single phase
or two phase
To power
supply
panel
Note:
For using thermostat limiters, see page 22-documentation
JB T JB/T