Tendzone TYCHO T 1212/CA - Manual (Page 36)

signal gain, reducing low level signal gain to maintain the overall system gain.
In the gain distribution type automatic mixer, a channel is not exactly open or closed, but located any state arbitrarily.
Relatively speaking, if the volume channel is higher, the gain is higher too . If several channels volume are the same, then
gains are equal. If a channel is almost no signal through, it almost no gain.
Figure 32
Each channel of automatic mixer has input, gain level meter and an automatic gain, channel fader, priority, and channel
muting.
Channel control: each channel has an automatic" AUTO " button, turn on the channel into the automatic mixing. If you
need a background music channel at a fixed level, or need to be a "chairman" Mic always remains in the open state, then
you need to push the “AUTO” off button on the automatically key. When a channel to select" AUTO " off the automatically
key, the gain will be automatically regulated, the channel signal level will not affect the other channel gain ( such as no
longer affects automatic mixer gain calculation ).
Channel mute and fader are automatic gain type, i.e., no matter how you act; there is no effect on automatic mixer. It
means that a particular channel is silent, if the high level signal on the channel is present, the remaining channels’ level
would also reduce. In order to mute a signal and prevent the signal effect automatic mixing, please open the mute and
turn “AUTO” off automatic mixer. Each channel of the mute function is to mute the channel in mix and mute the output
channel directly. Channel fader control the channel mix level and output level directly.
Priority control PR: allows the priority level high channel exceeding level of low passage, thus affecting the automatic audio
mixing algorithm.
The control grades from number 0 (lowest priority) to 10 (highest priority) the numerical definition of priority, the default
value is 5 (standard priority). User can control priority through the slider, also click on the edit box and enter the number
between 0 - 10 data adjusting priority. If the 2 channels are receiving a signal having the same level, high priority channel
will be a higher gain. Channels between each difference of 1 priority" units", the gain will differ 2dB ( if Slope is set in 2 ).
For example, in channel 1's priority is set to 6, channel 2 priority is set to 3, when the two channel receiving the same level