Tendzone TYCHO T 1212/CA - Manual (Page 32)

2.2.3EQ
The equalizer is used to compensate and modify the frequency characteristics, so that it can achieve the characteristic of
relatively flat frequency response Different models of equalizers are of different types, and the specific type shall be
subject to the actual model of the device.
Figure 27 5 band paragraph EQ
- The equalizer is to compensate and correct the frequency characteristics to make it reach a true and straight
frequency response characteristic.
- Bypass All: bypass all bands, the signal directly to the next processing module. Press down shows that EQ is disabled,
when popped up shows the EQ is enabled.
- Band Bypass: Range through-pass: after equalizer adjustment, you can cancel the bypass of certain set frequency
ranges. As long as you click to select the corresponding frequency range button, you can restore the original 0dB status,
inactivating the bypass of this band without affecting others.
- Center frequency: the frequency that needs equalization processing shall be between 20Hz and 20000Hz. When we
change the value, the icon of equalizer will also react synchronously.
- Gain: the gain/attenuation at the center of frequency. When the value is 0, the center frequency and Q value shall be
invalid.
- Q value: It means the bandwidth of frequency point. The more the value, the larger the bandwidth will be.