Ezbridge has two pcb versions – Teletronics EzBridge 5800 User Manual
Page 43
Appendix F: EzBridge Model Information and Compatible
Teletronics Wireless Cards
EzBridge has two PCB versions
PCB labeled with 29AB025XXX – Older EzBridge PCBs
• Uses Firmware 1.7.0 and below (Do not load firmware revision above 1.7.0) Power input is 7.5 DCV
through the PoE connection.
PCB labeled with 29AB234XXX – Newer EzBridge PCBs
• Uses Firmware 2.0.0 and above (Do not load firmware revision below 2.0.0). Power input is 9 DCV
through the PoE connection.
Note: Power input will vary depending on the length of the PoE run and the quality of the Ethernet cable (24 AWG) and
connectors.
Compatible Teletronics Wireless Cards
Teletronics 30mW PCMCIA card Model XI-300*, XI-325*, XI-330
Teletronics 100mW PCMCIA card Model XI-325H
Teletronics 200mW PCMCIA card Model XI-325HP
(Compatiable only with PCB 29AB234XXX, requires 9 VDC)
Teletronics 100mW PCMCIA card Standard Card
* Discontinued