Teletronics EzBridge 5800 - Manual (Page 10)

LED Status Function
On Power on.
Power
Off No power.
Blinking Blinking: Wireless LAN is transmitting.
On On: Wireless LAN connection is active. WLAN
Off Off: Wireless LAN connection is not active.
Blinking Blinking: Wired LAN is transmitting.
On On: Wired LAN is active. Ethernet
Off Off: Wired LAN is not active.
2.3 Installation
Preparation for Installation
Before the permanent install of the EzBridge 5800 the unit must be preconfigured within reach of a computer/laptop.
The configuration of the EzBridge 5800 is no different than setting up a regular EzBridge. Please ensure that all the
items listed in “1.4 System Requirements” are prepared, and then choose the place with the consideration of power
outlet and network connection to do the permanent install.
Hardware Installation
Follow the procedures below to fully install your EzBridge 5800:
1. Select proper location.
2. Mount the EzBridge by following the mounting instruction included in the EzBridge Kit.
3. Connect the Ethernet port on the NEMA4 box to the ODU side of the PoE. Then connect the NET side to the
internal Network. After both are connected connect the power adapter to the power jack on the PoE to power
on the EzBridge 5800. You may want to do a quick on on the LEDs to ensure the unit is getting power.
4. Now the hardware installation is complete, and you may proceed to the next chapter –“Configuring Windows
for IP Networking” for instruction on setting up network configurations.