Teletronics EzBridge 5800 - Manual (Page 17)

Info
Firmware Revision
Current firmware revision loaded on the EzBridge.
Connected to SSID
SSID in which the EzBridge is associated to.
Using Channel
If the EzBridge is associated with an AP or Bridge it will display the channel used.
MAC address of Access Point
The associated AP’s MAC address.
Current transmission rate (Mbits/s)
Displays the current maximum transmission rate established by the wireless link.
Current communications quality (%)
The communications quality is calculated in a ratio percentage based on the signal strength and noise.
MAC address of the wireless card
The MAC address of the wireless card plugged inside the EzBridge.
Current IP address
IP address assign on the unit.