beautypg.com

Preparing the remote control, Installing the battery, When to change the battery – Teac DA-3000 User Manual

Page 18: Warnings about battery use, Using the wireless remote control, 3 – preparations

background image

18

TASCAM DA-3000

3 – Preparations

Preparing the remote control

Installing the battery

NOTE

At the time of purchase, this remote control comes with a

lithium-ion coin battery (CR2025) installed. Before using the

remote control, pull the isolation sheet out of the battery

compartment.

1. Remove the battery holder.

While pressing 1, pull in direction 2.

2. Install a coin-shaped lithium ion battery (CR2025) into the

holder with the correct ¥/^ orientation.

3. Reinsert the battery holder into the remote control.

When to change the battery

Replace the battery with a new one if the remote control

operation range is reduced or if the buttons become

unresponsive.
Use a coin-shaped lithium-ion battery (CR2025).

Warnings about battery use

The accidental swallowing of a battery by a small child is

extremely dangerous. Keep batteries and remote controls out

of reach of small children. Consult a physician immediately if a

child should swallow a battery.
Misuse of a battery could cause it to leak, rupture or otherwise

be damaged. Please read and abide by the cautions related to

batteries. (See “CAUTIONS ABOUT BATTERIES” on page 4.)

• Install the coin-shaped lithium-ion battery with the correct

orientation.

• Do not recharge the coin-shaped lithium-ion battery.
• Do not heat or disassemble the coin-shaped lithium-ion

battery or put it into fire or water.

• Do not carry or store the coin-shaped lithium-ion battery

with small metal objects. Doing so could short the battery

and cause leakage or rupture, for example.

• When storing or disposing of batteries, cover the contacts

with tape to prevent them from touching other batteries

or metal objects.

• Follow the disposal instructions written on the battery or

given by the local government when you are done using

it.

Using the wireless remote control

Refer to page 14 for details about the functions of each

button.
When using the remote control, point it at the remote control

receiver on the unit within the angle shown below.

Remote Sensor

Operation distance
Directly in front: Within 7 meters
15° left or right: Within 7 meters

CAUTION

• The operation distance varies depending on the angle.
• If anything is between the remote control and the sensor,

operation might not work.

• Remove the battery if you will not use the remote control for

a long time (one month or more).

• If the battery should leak, thoroughly clean any residue from

inside the battery compartment and install a new battery.

• When using other devices controlled by infrared rays, use of

this remote control might operate these devices by mistake.