Studio Technologies 76DA V.4.12 - Manual (Page 28)

Issue 9, May 2014 Model 76DA/77 User Guide
Page 28 Studio Technologies, Inc.
for Surround
Configuration—Model 77 Device Address, Stereo Input C
Sample Rate Converter, and Post-Fader Stereo Digital and
Analog Monitor Output
Default: Device address A1.
Stereo input C sample rate converter enabled.
Post-fader stereo digital and analog monitor output can be enabled.
Note: The Model 77’s device address is the only parameter stored in the Model 77. All other parameters are stored
in the Model 76DA.
Press and hold the Mute/Solo button
to display and configure the Model 77’s
device address, stereo input C sample
rate converter, and post-fader stereo
digital and analog monitor output.
Use the Level control to change
this specific Model 77’s device
address. Address can be either
A1, A2, A3, or A4. See Note below.

These LEDs display the status of the post-fader stereo
digital and analog monitor output function. When
LED Surround is lit the function cannot be enabled.
When LED Stereo is lit the function can be enabled.
Use the button to change the configuration.
This LED displays the configuration of the
stereo input C sample rate converter
(SRC). LED not lit means SRC is disabled;
LED lit means SRC enabled. Use the button
to change the configuration.