SoundTraxx SoundCar Technical Reference - Manual (Page 39)

Tsunami SoundCar Technical Reference Page 37
CVs 49-52
Hyperlight Effect Select
Description
CVs 49-52 are used to set Hyperlight lighting effects and associated control
modes for their respective outputs.
CV 49, Headlight Effect Select
CV 50, Backup Light Effect Select
CV 51, FX5 Effect Select
CV 52, FX6 Effect Select
EF0-EF3: Effect Type Select
0 = On/off output
1 = Rule 17 dimmable headlight
2 = Mars Light
3 = Pyle-National Gyralite
4 = Oscillating headlight
5 = Single-flash strobe
6 = Double-flash strobe
7 = Western-Cullen D312 rotary beacon
8 = Prime Stratolite
9 = Type I ditch light
10 = Type II ditch light
11 = Flashing rear-end device (FRED)
12 = Engine exhaust flicker
13 = Firebox flicker
14 = Reserved
15 = Dyno-light
Rule 17 dimmable headlight – This function output is normally an
on/off output. When it is on, the output level will be reduced by
approximately 60% when the dimmer function is activated.
Mars Light – This effect simulates the sweeping figure-8 pattern of
this popular warning beacon.
Pyle-National Gyralite – The Gyralite is similar to the Mars Light, but
generates a slow, wide-sweeping elliptical headlight pattern.
Oscillating headlights – Similar in appearance to the common
twin-sealed-beam headlight, the oscillating headlight uses a moving
reflector to sweep the headlight beam in a tight circular motion.
Lighting Effect CVs
Bit 7 Bit 0
LED R17 XING PHSE EF3 EF2 EF1 EF0