SoundTraxx SoundCar Technical Reference - Manual (Page 11)

Tsunami SoundCar Technical Reference Page 9
Primary CVs
CV 14
Analog Function Enable 2
Description
CV 14 defines whether functions 9-12 are active during analog mode
operation. If a bit is set to 1, the corresponding function will be mapped to the
output defined in CVs 33-46.
F0(f): F0 Forward Enable
0 = Function is disabled for analog operation
1 = Function is enabled for analog operation
F0(r): F0 Reverse Enable
0 = Function is disabled for analog operation
1 = Function is enabled for analog operation
F9-F12: Analog Function Enable
0 = Function is disabled for analog operation
1 = Function is enabled for analog operation
0: Not used. Must be set to 0.
Note: This CV is most useful for turning on lighting effects when running on
a DC-powered layout. Sound functions may be turned on in analog mode,
but this is less useful because they will either run continuously or sound
only once when the decoder powers up. Instead, use the automatic sound
functions (CV 197) to generate sound effects in analog mode.
Default Value: 3
Related CVs: CVs 33-46 (Function Output Maps)
CV 197 (Analog Mode Automatic Sound Configuration)
Bit 7 Bit 0
0 0 F12 F11 F10 F9 F0(r) F0(f)