SoundTraxx SoundCar Technical Reference - Manual (Page 10)

Tsunami SoundCar Technical Reference Page 8
Primary CVs
CV 13
Analog Function Enable 1
Description
CV 13 defines whether functions 1-8 are active during analog mode
operation. If a bit is set to 1, the corresponding function will be mapped to the
output defined in CVs 33-46.
F1-F8: Analog Function Enable
0 = Function is disabled for analog operation
1 = Function is enabled for analog operation
Note: This CV is most useful for turning on lighting effects when running on a
DC-powered layout. Sound functions may be turned on in analog mode, but
this is less useful as they will either run continuously or sound just once when
the decoder is powered up. Instead, use the automatic sound functions
(CV 197) to generate sound effects in analog mode.
Default Value: 0
Related CVs: CVs 33-46 (Function Outputs)
CV 197 (Analog Mode Auto Sound Configuration)
Bit 7 Bit 0
F8 F7 F6 F5 F4 F3 F2 F1