Sloan AC-450 Act-O-Matic Institutional Showerhead - Manual (Page 2)

If you have questions about how to install
your Sloan Showerhead, consult your local
Sloan Representative or call Sloan Installation
Engineering Department at:
1-888-SLOAN-14 (1-888-756-2614)
OR 1-847-233-2016
2
INSTALLATION (CONT.)
Step 3 — Install Pipe Fitting (Figure 2)
Coat threaded end of water supply line with pipe dope or wrap with sealing tape. Thread pipe fitting onto water supply line using a 1-3/8" wrench.
Step 4 — Mount Shower Head Assembly
Wet pipe fitting “O” Ring with water to lubricate and carefully slide shower head assembly over pipe fitting. Be careful not to damage pipe fitting “O” Ring. Secure
shower head assembly to mounting plate using two (2) Tamper-Proof, shower head assembly screws provided.
AC-450 AC-460
Step 5 — Adjust Direction of Stream
To change direction of stream from the preset 30 degree angle, loosen adjustment
screw located at top of shower head, move ball to the desired position and secure
adjustment screw.
CARE AND CLEANING
DO NOT use abrasive or chemical cleaners to clean shower head as they may dull the luster and attack the chrome or special decorative finishes. Use ONLY
soap and water, then wipe dry with clean cloth or towel. While cleaning the bathroom tile, the shower head should be protected from any splattering of cleaner. Acids
and cleaning fluids will discolor or remove chrome plating.
SLOAN • 10500 SEYMOUR AVENUE • FRANKLIN PARK, IL 60131
Phone: 1-800-982-5839 or 1-888-756-2614 • Fax: 1-800-447-8329 or 1-847-671-4380 • www.sloanvalve.com
© 2012 Sloan Valve Company Code No. 0816192 – Rev. 2 (07/12)
PARTS LIST
Item No. Part No. Description
1. AC-450 Shower Head Asembly
2.† SH-511 Pipe Fitting
3A.† SH-1010-A Flow Control, 2.5 gpm (9.4 Lpm)
3B.† SH-1020-A Flow Control, 2.0 gpm (7.5 Lpm)
4.† SH-512 “O” Ring
5. SH-514 Shower Head Mounting Screw (2)
6. —— Mounting Plate
7. K-57 Anchor (4)
8. SH-37 Mounting Screw (4)
† Items 2, 3A and 4 are supplied assembled.
1.
2.
3.
4.
5.
6.
7.
8.
AC-450
Item No. Part No. Description
1. AC-460 Shower Head Asembly
2.† SH-511 Pipe Fitting
3A.† SH-1010-A Flow Control, 2.5 gpm (9.4 Lpm)
3B. SH-313-A Flow Control 2.0 gpm (7.5 Lpm)
4†. SH-512 “O” Ring
5. —— Mounting Plate
6. —— Stud (
¼”-28) (2)
7. —— LockWasher (2)
8. —— Hex Nut (2)
† Items 2, 3A and 4 are supplied assembled.
1.
2.
4.
AC-460
Protect the chrome or special finish of
ACT-O-Matic® Showerheads —
DO NOT USE toothed tools to install or
service these valves.
!!! IMPORTANT !!!
3.
5.
6.
7.
8.