Skutch Electronics AS-80 - Manual (Page 12)

AS-80 Alarm Dialer
Version 2.00
Quick Programming Guide
After initial BEEP enter access code:
===Tone Command Codes======
* 0x = Delay (x=1-9 seconds)
*2 = Wait for 5 seconds of Silence.
*3= Dial a STAR Touch Tone
*4= Dial a POUND Touch Tone
*8= Next tone, sound for 6 seconds
*9=No Annoucement Play
==== Pulse Command Codes ======
**=Switch to Tone Dialing
*x=Delay(x=1-9 seconds)
= Playback Announcement #1
= Playback Announcement #2
= Record Ann. #1, Press POUND to end.
= Record Ann. #2, Press POUND to end.
= to Bypass.
Phone Number Entry
(Phone Number) then
= Turn ON Channel #1
= Turn ON Channel #2
Output Control
System Setup Info
0 1 1 02 10 10 2 0
Dial Method
0=Tone
1=Pulse
(0-1)
Redials for #1
(0-9)
Redials for #2
(0-9) Rings Until
Answer (01-29)
Output #1 Control
0.1 to 9.8 Minutes
99=LATCH ON
(01-99)
Output #2 Control
0.1 to 9.8 Minutes
99=LATCH ON
(01-99)
Answer Detect
0=Tone to RESET
1=Noisy Lines
2=Normal Answer Detect
(0-2)
Announcement
Double
Confirmation
0=No 1=Yes
Entry MUST be from 2 to 32 characters long.
<1> <#> at beginning to ERASE phone number
# of BEEPS indicate the phone number you are on (1-4)
# at beginning to leave phone number unchanged.
29=Ring 2 Times,
Hang Up, Count to
5,Call Back within
40 seconds.
= Turn OFF Channel #1
= Turn OFF Channel #2
= To Bypass
Start here for Local Programming
= To Bypass