Skutch Electronics CK-1P5 - Manual (Page 2)

Page 2 of 4
buttons. Note that the LEDs are located on the left hand side of the buttons. Once you are
SURE it is aligned, press down to attach to phone. The Sensor Board is aligned to the
edges of the phone as shown in Fig. 2.
CAUTION: The SENSOR BOARD must be aligned correctly or the unit will not
operate properly. If you need to remove the SENSOR BOARD once it is attached,
slowly lift up on one edge of the SENSOR BOARD. Pulling the SENSOR BOARD off
fast could damage the foam pad.
3- Position the CK-1P5 box under the base telephone with the jacks facing towards the
back of the phone. (See Fig. 3).
4- Connect the SENSOR BOARD CABLE between the CK-1P5 Box and the SENSOR
BOARD as shown in Fig. 3. Make sure that all 10 pins are aligned, and that the notch on
the connector is UP!
5- Connect the short modular cord from [1&2 to Phone] on CK-1 to [LINE 1/2] on
Phone.
6- Connect the short modular cord from [3&4 to Phone] on CK-1 to [LINE 3/4] on
Phone.
7- The audio cord that comes with the CK-1P5 is ONLY used for CD Players. If you
have a digital player, then you should be using the audio cord that came with your digital
Align edge on
Sensor Board t o
t his line on t he phone
Align edge on
Sensor Board t o
t his line on t he
phone
Fig. 2 Sensor Board Alignment