Skutch Electronics CK-1P5 - Manual (Page 3)

Page 3 of 4
unit. Connect the proper audio cord from your music source, to the AUDIO IN jack on
the back of the CK-1 box.
8- Connect a MOD cord from Telephone Wall Jack 1&2 to [1&2 to Line] on CK-1.
9- Connect a MOD cord from Telephone Wall Jack 3&4 to [3&4 to Line] on CK-1.
10- Connect the POWER CUBE from the CK-1 box to 115VAC power.
Sensor Board
Audio Jack
Fig. 3
LINE 1/ 2
LINE 3/ 4
Testing the System:
1- Pickup line 1 on your telephone. The line one LED on the SENSOR BOARD should
light up.
2- Repeat this test for lines 2-4. If all lines light up when picked up, the CK-1 is working
properly. If the lights on the SENSOR BOARD do not light up, then
a) Make sure that the CK-1P5 and Phone is connected to power.
b) Make sure that the SENSOR BOARD is aligned properly.
I hear Music when I pick up the phone
It is normal to hear a burst of music when a call is picked up from a HOLD condition.
The maximum length of the burst should be under 1 1/2 seconds. This is normal and is
due to the communication structure of this family of phones.
Lights on CK-1 Box.
When you place a line on HOLD, the corresponding LED on the rear of the CK-1P5 box
lights up to confirm the Promotion-On-Hold condition.