Skutch Electronics CK-2 - Manual (Page 3)

Page 3 of 5
5- Connect a telephone cord from each line 3&4 jack on each telephone, a CK-2 jack that
is labeled "Phone 3 & 4". Order does not matter.
6- Connect a audio cable from your audio source to the Audio In jack on the CK-2. Use
the audio cable supplied with the CK-2 ONLY if your audio source is a CD player. If you
are using a digital player, the digital player should have come with the needed audio
cable.
7- Connect the CK-2 and all telephone's power cubes to power.
Method #2 Installation:
This method should be used when your phones are spread out over a wide area It
requires that 4 telephone jacks be installed by a qualified person, in-between ALL
PHONES, and the telephone company. The DEMARCATION POINT is one place that
these jacks could be installed. The following diagram shows the relative location of these
jacks:
The following is a wiring diagram of how the jacks are to be installed:
Telephone Pole Demarcation Point
Office
Install Jacks within
this area