Scotsman SCE275 - Manual (Page 32)

SCE275
January 2003
Page 32
Removal and Replacement: Inlet Valve & Water Trough
Water Inlet Valve
The water inlet valve is located in the lower back of
the cabinet. The hood and bin must be removed to
gain access to this part.
The valve is directly connected to the incoming
water supply. With the water supply turned off, the
connection can be removed from the front of the
machine.
1. Go thru the steps on page to remove the hood
and bin.
2. Locate the inlet water valve. Pull the wire harness
off the terminals of the valve.
3. Remove the cover over the utility connections.
4. Use two wrenches and loosen the nut on the male
flare holding the water supply to the water inlet
connection. Remove the water supply line from the
water inlet valve.
5. Remove the two screws that hold the water inlet
valve to the cabinet.
6. Pull the water inlet valve out and remove the
discharge hose from the outlet of the valve.
7. The valve may now be removed from the ice
machine.
8. Reverse steps 7-1 to replace the valve.
Water Trough
1. See the next page and remove the bin controls
first (steps 1-9).
2. Pull out the cube deflector.
3. Unsnap the trough from the evaporator pins and
rotate the front trough out of the machine.
4. Unsnap the trough from the evaporator pins and
rotate the back trough out of the machine.
5. Reverse to reassemble. Note: The troughs are
marked: FRONT TROUGH and BACK TROUGH.
Begin by hanging the troughs on the evaporator’s
front pins and then rotating the trough until it snaps
onto the back set of pins. Be certain that all 4 pins
are engaged on each trough.
View of Machine Without Bin or Hood
Inlet Water
Valve
Cover Removed From
Utility Bracket