Scotsman SCE275 - Manual (Page 24)

SCE275
January 2003
Page 24
Additional Maintenance: Bin Controls
The bin controls use a system of infrared emitting
and receiving components to sense the build up of
ice in the bin. They are located in between the
evaporators. They must be free of mineral build up
to function properly. To check:
1. Remove the right front grill.
2. Push and hold the off button until the machine
stops..
3. Remove the knobs holding the hood to the bin.
4. Remove the hood..
5. Remove the thumb screws holding the bin
control brackets.
6. Lift the the bin control brackets up and out from
between the evaporators.
7. Examine the bottom of the brackets, there are
two sensors in each bracket, check that they are
clear of mineral build up. They may be wiped clean
with ice machine cleaner to assist in removal of the
build up. Use a toothbrush if necessary to remove
scale.
Be sure to drain the reservoir or go thru a Clean
cycle to remove residual cleaner.
Note: Do NOT use abrasive materials or cleaner
on the bin sensor lenses.
Removal of Bin Controls
Thumb Screw
Bin Controls,
Clean Here