Scotsman C0522R - Manual (Page 9)

January 2014
Page 8
C0522 through C1030
Remote Condenser Models - User Manual
Panel Removal
1. Locate and loosen the two screws at the front
edge of the top panel.
2. Pull the front panel out at the top and lift it up and
off the base.
3. Remove two screws at the front edge of the top
panel, and lift up the top panel until it clears the
front of the side panels, then push back 1” and lift
it up and off the machine.
4. Locate and loosen the screws holding each side
panel to the base.
5. Pull the side panel forward to release it from the
back panel.
This manual covers several models of remote cubers.
The model number on the ice machine can be found
either on the dataplate, which is on the back panel, or
the serial number tag, which is behind the front panel.
See the illustration for the locations of the dataplate
and the serial number tag.
The remote condenser has a separate model and
serial number. Its model and serial number is on the
dataplate on the condenser near the quick connect
fittings.
Write the model and serial numbers here:
Model Serial Number
Ice machine
Bin
Condenser
Write the day of start up here:_______________
Switch Bezel
All models ship with the On and Off switches front
accessible. if desired, the On and Off switches can be
covered up to prevent unauthorized use by changing
the bezel in the front panel's trim strip. A cover up
bezel is available from the local Scotsman distributor.
Uncrate and Set Up
Begin with the ice storage bin or dispenser. If a bin,
remove the carton, and, using part of the carton as
a cushion, tip the bin on its back to remove the skid.
Attach the supplied legs or optional casters. Return
the bin to a normal, upright position.
Check the bin top gasket for rips or gaps. If recycling
an older bin, replace the gasket or repair with food
grade sealant prior to placing the ice machine on the
bin.
Install the bin top adapter or ice dispenser adapter, if
one is required for the application.
If the ice machine has not been unpacked, do so now.
Remove the carton from the skid. Lift the ice machine
off the skid directly onto the bin.
Note: The machine is heavy. Use a mechanical lift if
necessary.
Secure the ice machine to the bin with the hardware
provided (two metal straps and four bolts).
Place the bin and ice machine in the selected location
and level it using the bin leg levelers.
2
2
5
5
1. Remove
Screws
4. Remove
Screws
Dataplate
Location
3
Dataplate Location and panel Removal