Remotec Z-URC550 V1 User Manual

Page 34

Suggestions:

• If you cannot find a correct Device Code for your equipment, refer

to AV Equipment Selection by Searching through the Library.

• For future reference you are recommended to take note of your

Devices codes in the space provided in the manual after setting up
the Z-URC

550EU correctly.

AV Equipment Selection by Searching through the
Library

If you cannot identify a correct Device Code for your equipment from
the Device Code list, you may search for the code in the library:
1. Turn on your device manually (e.g. TV).
2. Press a desired Device Mode Key (e.g. TV).
3. Press and hold "CH +" and "VOL -" on the Z-URC

550EU

simultaneously for 3 seconds until the indicator lights up.

4. Enter a corresponding Magic Search Code from the following

table. The green indicator flashes twice then goes out.

Device to be searched from

code library

Magic Search

Code

TV 0001
VCR 0002
SAT / DVB-T

0003

CTV 0004
DVD / TER

0005

(e.g. press "TV" device mode key, then press "CH +" and "VOL -", and
enter TV Magic Search Code 0001.)

5. Press the same desired device mode key again as in step 2 above.

(e.g. TV)

6. Press and hold "CH +" & "VOL -" simultaneously for 3 seconds

until the green indicator lights up, and your Z-URC

550EU is

ready to start searching.

7. Aim the Z-URC

550EU at your device (e.g. TV), press the

key slowly and repeatedly until the device has been turned

off. Once your device has been turned off, immediately press
Device Mode Key (e.g. TV) to lock in code and the indicator
should go out.

Simply repeat the above setup procedures to search for the Device
Code for SAT/CBL, DVD or AUX. (Remember to press the
correct Device Mode Key and correct Magic Search Code in step
2-5 above)