Remotec Z-URC550 V1 User Manual
Page 18

18
4
Press the program/EP
button on the secondary
device (e.g. light switch)
• “OK" LED flashes
once and stays on
• “LED_B" flashes once
and keep blinking slowly
5
Press the program/EP
button on the primary
device (e.g. door sensor)
• “LED_B" turns off
• “OK" LED flashes
once then turns off
• Assigning association
completed
Note1: Your target device must be included in the network before this
setup procedure, please refer to [Adding Device to the Network]
section.
Removing Device/End-point from an Association Group
Step
Setup Key
LED Indication Status
1
Press
in Advance
Setup
• The “OK" light turns
on
2
Press
• “OK" LED flashes
once and stays on
• “LED_A" flashes
slowly
3
Select a group number
from 1 to 16 (1-8 or
1-8)
• “OK" LED flashes
once and stays on
• “LED_A" off
• “LED_B" flashes
slowly
4
Press the program/EP
button on the secondary
device (e.g. light switch)
• “OK" LED flashes
once and stays on
• “LED_B" flashes once
and keep blinking slowly
5
Press the program/EP
button on the primary
device (e.g. door sensor)
• “LED_B" turns off
• “OK" LED flashes
once then turns off
• Device removed from the
association group
successfully
Note1: This process will only remove the target device/EP from its
assigned association group but will not exclude it from the network.