Remotec Z-URC550 V1 - Manual (Page 19)

19
Deleting an Association Group
Step Setup Key LED Indication Status
1
Press in Advance
Setup
• The “OK＂ light turns
on
2
Press
• “OK＂ LED flashes
once and stays on
• “LED_A＂ flashes
slowly
3
Select a group number
from 1 to 16 (1-8 or
1-8)
• “OK＂ LED flashes
once and stays on
• “LED_A＂ off
• “LED_B＂ flashes
slowly
4
Press the program/EP
button on the primary
device (e.g. door sensor)
• “LED_B＂ turns off
• “OK＂ LED flashes
once then turns off
• Deleting the association
group successfully
Note1: This process will only remove the group devices/EPs from its
assigned association group but will not exclude it from the network.