Remotec Z-URC550 V1 - Manual (Page 10)

10
Note2: XpressZetup
TM
cannot support “Multi-Channel Device”, please
refer to [Adding Device to the Network] and [Adding Device/End-point
to a group] for normal setup procedure.
Removing Device from a Group
Step Setup Key LED Indication Status
1
Press in
XpressZetup
TM
area
• “OK＂ LED on
• “LED_A＂ flashes
rapidly
2
Select a group number
from 1 to 16 (1-8 or
1-8)
• “LED_A＂ off
• “LED_B＂ flashes
rapidly
3
Press the program button
on the target device
• “OK＂ LED flashes once
then turns off
• Device been removed from
the Group successfully
Note1: If the ERROR LED turns on or flashes, meaning the setup
process is failed. Please redo the process.
Note2: XpressZetup
TM
cannot support “Multi-Channel Device”, please
refer to [Removing Device/End-point from a group] for normal setup
procedure.
Note3: This process will only remove the target device from its
assigned group but will not exclude it from the network.
Removing all Devices from a Group
Step Setup Key LED Indication Status
1
Press and hold
in XpressZetup
TM
area
• “OK＂ LED on
• “LED_A＂ flashes
rapidly
2
Select a group number
from 1 to 16 (1-8 or
1-8)
• “LED_A＂ off
• “LED_B＂ flashes
rapidly
• “OK＂ LED flashes once
then turns off
• Device been deleted from
the Group successfully
Note1: If the ERROR LED turns on or flashes, meaning the setup
process is failed. Please redo the process.