Remotec Z-URC550 V1 - Manual (Page 21)

21
Adding Devices to All Control
Step Setup Key LED Indication Status
1
Press in Advance
Setup
• The “OK＂ light turns
on
2
Press and hold the key
for 2 seconds which you
want to add to the front
top side
Example:
i) Press key to add
to all-on function,
ii) Press key to add
to all-off function,
iii) Press and hold
keys
simultaneously for 2
seconds to add to
both all-on and all-off
function.
• “LED_B＂ flashes
slowly
3
Press the program button
on the target device
• “LED_B＂turns off
• “OK＂ LED flashes
once then turns off
• Adding Device from All
Control successfully
Note1: The factory default setting for Z-URC
TM
550EU is to be
included in All-On and All-Off control. The above section should only
be needed if the device has been deleted from All Control.