Remotec Z-URC550 V1 - Manual (Page 24)

24
Copying Network Information to a Secondary Controller
You can add a secondary controller to your network and copy all of
your primary controller’s network information to the secondary
controller by following the steps below.
Step Setup Key LED Indication Status
1
Press & hold
for 3 seconds
• “OK＂ LED on
2
Place the two controller
close to each other -
3
Type “8542＂ on the
setup number keypad
• “OK＂ LED flashes
once for each number
input
• “OK＂ LED keeps
blinking after entering
the 4-digit
4
Please make sure the
target controller is setup
to receive information.
(Refer to the target
controller user manual
for more information)
• “OK＂ LED flashes
once then turns off
• Replication completed
Note1: If the replication is unsuccessful, the “OK” light turns off and
the error light will flash 6 times then turn off.