Remotec Z-URC550 V1 - Manual (Page 14)

14
scene successfully
Note1: This process will only remove the target device/EP from its
assigned scene but will not exclude it from the network.
Deleting a Scene
Step Setup Key LED Indication Status
1
Press in Advance
Setup
• The “OK＂ light turns
on
2
Press
• “OK＂ LED flashes
once and stays on
• “LED_A＂ flashes
slowly
3
Select a scene number
from 1 to 16 (1-8 or
1-8)
• “OK＂ LED flashes
once then turns off
• “LED_A＂ off
• Scene deleted from the
scene successfully
Note1: This process will only remove the scene devices/EPs from its
assigned scene but will not exclude it from the network.
Note 2: The above steps are needed if Z-URC
TM
550EU to be a
secondary remote controller and the Scene information mapping from
gateway / primary controller is unsuccessful.
Scene Operation
After the scene setup is done, you can trigger the desired scene via
scene control keys in front panel of the Z-URC
TM
550EU. (Figure 4)
The green “OK＂ LED flashes when the operation is successful, and
the red ERROR LED flashes when it’s failed.
Figure 4 Scene Control Keys of the Z-URC
TM
550EU
Scene
Control Keys