Remotec Z-URC550 V1 - Manual (Page 13)

13
1-8)
• “LED_B＂ flashes
slowly
4
Press the program/EP
button on the target
device
• “OK＂ LED flashes
once and stays on
• “LED_B＂ keep
blinking slowly
5
Adjust the target device
on/off or dim level with
its program button, to the
desired status -
6
Press
• “OK＂ LED flashes
once then turns off
• “LED_B＂ off
• The current status of the
device will be learned
and saved to a scene
successfully
Note1: Your target device must be included in the network before this
setup procedure, please refer to [Adding Device to the Network]
section.
Removing Device/End-point from a Scene
Step Setup Key LED Indication Status
1
Press in Advance
Setup
• The “OK＂ light turns
on
2
Press
• “OK＂ LED flashes
once and stays on
• “LED_A＂ flashes
slowly
3
Select a scene number
from 1 to 16 (1-8 or
1-8)
• “OK＂ LED flashes
once and stays on
• “LED_A＂ off
• “LED_B＂ flashes
slowly
4
Press the program/EP
button on the target
device
• the “OK＂ light stays
on then flashes once and
turns off
• “LED_B＂ off
• Device removed from the