REMKO Condensate Catch Tray With Oil Separator - Manual (Page 6)

6
REMKO
WITH INTEGRATED OIL SEPARATOR
CONDENSATE CATCH TRAY
Installation in connection with wall-mounted consoles
D
B
A
C
T
T
Local regulations or environmental laws, for example the German Water Resource Act
(WHG), can require that suitable precautions be taken to protect against uncontrolled
drainage in case of leakage to provide for safe disposal of escaping air conditioning
fluid or hazardous media.
The oil protector with integrated oil separator, for the fluids WGK1- GK3, prevents
any oil that might be in the oil tray from being rinsed out by rainfall. The oil is held
back completely and kept from running out. Condenser sets installed on the oil tray
will not result in water contamination in the event of leaks.
Select the fastening material suitable for the wall to which the condensate catch tray is
to be fastened!
Install the wall-mounted console to the building only where structurally permitted.
Make sure when drilling to place anchors that there are no supply lines where you are
drilling.
The wall-mounted console must be fastened so that it can carry the weight of the unit.
Make sure that no vibrations are transferred to the masonry. If necessary, install
insulation (see accessory programme).
Refrigerant lines and electrical lines must be installed from the rear or from the right,
not from below!
NOTE