REMKO Condensate Catch Tray With Oil Separator - Manual (Page 13)

13
Installation in connection with floor consoles
Preparation
1. Align the two floor consolesat the
same elevation, at the distance of the
outdoor component's anchor feet, and
at a 90° angle to the outdoor unit.
2. If necessary mark the positions of the
bores at which the anchors for the
floor consoles will be set (protection
against tipping).
3. Drill the holes and secure the floor
consoles using the appropriate
anchors.
4. Align the floor consoles and correct
for any unevenness in the surface
so that the floor consoles stand
horizontally.
Make sure the surface is level and
can carry the load!
An adequate surface is provided
by two foundation strips or by
securely anchored garden pavers
(paving stones), set at the correct
distance from one another
We recommend a gravel layer for
the area between the consoles.
Make sure to provide for sufficient
protection against tipping. Anchor
the floor consoles to the surface if
necessary!
Refrigerant lines and electrical
lines must be installed from the
rear or from the right, not from
below!
NOTE